H3C Technologies H3C Intelligent Management Center User Manual
Page 145
127
{
Deploy VLAN—ID or name of the VLAN to be assigned to the user through the access device.
The value range of the VLAN ID is 1 to 4094. Other value is considered as a VLAN name.
{
Deploy User Profile—Name of the user profile to be assigned to the user through the access
device.
{
Deploy User Group—Name of the user group to be assigned to the user through the access
device.
{
Deploy ACL—Number or name of the ACL to be assigned to the user through the access device.
Authentication Binding Information area parameters:
All options selected in this area must be checked in network access authentication.
{
Bind Access Device IP—Requires the access device use the bound IP address.
{
Bind Access Device Port—Requires the user endpoint connect to an access device through the
bound port.
{
Bind VLAN—Requires the packets of the user carry the bound VLAN tag.
{
Bind QinQ Double VLAN—Requires the QinQ packets of the user carry the bound VLAN tags.
{
Bind User IP—Requires the authenticated NIC on the user endpoint use the bound IP address.
{
Bind User IPv6—Requires the authenticated NIC on the user endpoint use the bound IPv6
address.
{
Bind User MAC—Requires the authenticated NIC on the user endpoint use the bound MAC
address.
{
Bind User IMSI—Requires the user endpoint use the bound IMSI.
{
Bind Computer Name—Requires the user endpoint use the bound computer name.
{
Bind Domain—Requires the user endpoint join the bound Windows domain. The user does not
need to log onto the domain.
{
Logon Domain—Requires the user endpoint log on to the bound domain.
{
Bind User SSID—Requires the bound SSID be used.
{
Bind Access Device SN—Requires the access device use the bound serial number.
{
Control Access MAC Address—Checks the MAC address of the user endpoint. For more
information, see "
Configuring access MAC addresses
{
Control Hard Disk Serial Number—Checks serial numbers of the hard disks on the user endpoint.
For more information, see "
Configuring hard disk serial numbers
{
Enable SSID Access Control—Checks the SSID to which the user endpoint is connected. For more
information, see "
."
User Client Configuration area parameters:
{
iNode Client Only—Whether user authentication must be performed through the iNode client.
{
Disable iNode DC for Windows—Blocks use of the iNode DC on Windows endpoints.
{
Disable iNode DC for Linux/Mac OS—Blocks use of the iNode DC on Linux and Mac OS
endpoints.
{
Forbid Modifying IP When Online—Disables an online user from modifying the endpoint's IP
address. Otherwise, the user is logged out.
{
Auto Reconnect after Network Failure—Enables the iNode client to automatically reconnect if
the user connection is closed because of a network failure.
{
Retry Interval (Minutes)—Interval at which the iNode client automatically reconnects, in minutes.
This parameter appears only when the Auto Reconnect after Network Failure option is selected.