H3C Technologies H3C Intelligent Management Center - Manual (Page 608)

590
Configuring authentication notify parameters
The authentication notify function uses the following working mechanism:
• When a user passes authentication or logs offline, UAM sends a message to a third-party system.
• The third-party system receives the message and then sends a short message or an email to the user.
The sending method and the message are configured in the third-party system.
To configure the authentication notify parameters:
1. Click the User tab.
2. Select User Access Policy > Service Parameters > System Settings from the navigation tree.
The list includes all the system settings.
3. Click the Configure icon for Authentication Notify Parameters.
4. Select Enable Authentication Notify.
5. Configure the following parameters for UAM to cooperate with the third-party system:
{
Server's IP—Enter the IP address of the third-party system.
{
Port of Server—Enter the port number to which the third-party system listens for UAM messages.
{
Shared Key—Enter the key that UAM and the third-party system use to authenticate each other.
The value must be the same as what is configured on the third-party server.
{
Confirm Shared Key—Enter the same shared key as the value in the Shared Key field.
6. Click OK.
Configuring client anti-crack
Restrictions control the use of network resources by normal authenticated users. However, unauthorized
users bypass authentication and access control by cracking, tempering and spoofing clients, so their use
of network resources is not restricted.
To prevent unauthorized access to the network, UAM works with the iNode management center to
provide the client anti-crack function. This function is available only for 802.1X and portal access.
The client anti-crack function protects the iNode client in various scenarios when an iNode management
center is added to UAM.
Viewing the iNode management center list
1. Click the User tab.
2. Select User Access Policy > Service Parameters > System Settings from the navigation tree.
The list includes all the system settings.
3. Click the Configure icon for Client Anti-Crack.
The Client Anti-Crack page displays all iNode management that are added to UAM.
{
IP Address—IP address of the iNode management center.
{
Remarks—Remarks of the iNode management center.
{
Status—Status of the iNode management center. The Valid state indicates the iNode clients
installed or upgraded using the management center support the client anti-crack function. The