beautypg.com

Sic-3g-gsm, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual

Page 93: Interface leds

background image

2-73

Step1 Open the UIM card socket following the direction as shown on the UIM card socket.

Step2 Insert the UIM card into the UIM module socket.

Step3 Close the UIM card socket following the direction as shown on the UIM card socket.

Step4 Execute the display cellular [slot]/0 all command after the router is started. When “UIM Status = OK”

appears in the output information, the UIM card is identified.

SIC-3G-GSM

Introduction

The SIC-3G-GSM module serves to access 3 G WLANs. It supports:

z

GPRS

z

EDGE

z

UMTS

z

HSDPA

Interface attributes

Table 2-60 Interface attributes of the SIC-3G-GSM module

Attribute

Description

Connector type

TNC: For connecting an antenna and accessing WLANs.
RJ-45: For connecting to a third-party WLAN debugging and testing software
such as CAIT of Qualcomm.

Number of connectors

1 TNC RF
1 RJ-45

Interface standard

TNC RF: Omni antenna, supporting GPRS/EDGE/UMTS/HSDPA.
RJ-45: RS232

Cable type

TNC RF: None
RJ-45: AUX cable

Rates

z

HSDPA (downlink: 7.2 Mbps)

z

HSUPA (uplink: 5.76 Mbps)

z

UMTS (downlink: 384 Mbps, uplink: 384 Kbps)

z

EDGE (downlink: 236.8 Kbps, uplink: 236.8 Kbps)

z

GPRS (downlink: 85.6 Kbps, uplink: 85.6 Kbps)

Services GPRS/EDGE/UMTS/HSDPA

Interface LEDs

SIC-3G-GSM panel is shown in the following figure:

Figure 2-89 SIC-3G-GSM panel

The following table describes the LEDs on the SIC-3G-GSM panel:

This manual is related to the following products: