beautypg.com

Interface leds, Table 4-46 set the jumpers on the fic-4bse – H3C Technologies H3C MSR 50 User Manual

Page 249

background image

4-54

Table 4-46 Set the jumpers on the FIC-4BSE

Jumper settings & description

Default

S2

z

To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

Interface 0

S1

z

To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

S4

z

To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

Interface 1

S3

z

To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

S6

z

To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

Interface 2

S5

z

To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

S8

z

To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

Interface 3

S7

z

To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.

z

To do otherwise, place the jumper over jump pins 2 and 3.

z

See

Figure 4-65

.

The jumpers are
placed over
jump pins 2 and
3, meaning
100-ohm
matched
resistances are
not used.

Interface LEDs

The following figure illustrates the FIC-4BSE panel.

Figure 4-66 FIC-4BSE panel

The following table describes the LEDs on the module panel.

Table 4-47 LEDs on the FIC-4BSE panel

LED

Description

LINK

z

OFF means no link is present.

z

ON means a link is present.

This manual is related to the following products: