Fic-1ce3, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual
Page 241: Interface leds
4-46
FIC-1CE3
Introduction
FIC-1CE3, the 1-port channelized E3/fractional E3 interface module, delivers these functions:
z
In E3 mode, transmitting, receiving, and processing one channel of E3 fast traffic; providing E3
traffic access.
z
In CE3 mode, providing the subscribers with N × 64 kbps low-speed access, where N is smaller
than or equal to 128.
E3 represents the tertiary group rate of E system in the TDM system, that is, 34.368 Mbps. Through
E23 and E12 demultiplexing, an E3 channel can be channelized into 16 E1 lines, each supporting both
the E1 and CE1 modes. E23 means either E2-to-E3 multiplex or E3-to-E2 demultiplex, and E12 means
E1-to-E2 multiplex or E2-to-E1 demultiplex. “E23” and “E12” discussed here represent the demultiplex
process.
Interface attributes
The following table describes the interface attributes of the FIC-1CE3/FIC-2CE3.
Table 4-37 FIC-1CE3 interface attributes
Attribute
Description
Connector SMB
Number of connectors
2
Interface standard
G.703
G.704
G.751
Interface rate
34.368 Mbps
Cable type
E3 cable (75-ohm coaxial cable)
Operating mode
E3
CE3
Supported service
E3 leased line
Interface LEDs
The following figure illustrates an FIC-1CE3 panel.