Introduction, Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual
Page 224
4-29
z
FIC-4T1-F
z
FIC-1CE3
FIC-1E1/FIC-2E1/FIC-4E1 and FIC-1E1-F/FIC-2E1-F/FIC-4E1-F
Introduction
1) FIC-1E1/FIC-2E1/FIC-4E1
FIC-1E1/FIC-2E1/FIC-4E1, the 1-/2-/4-port channelized E1/PRI interface module, transmits, receives,
and processes E1 data traffic. In addition, you can use the module for other purposes, such as CE1
access and the ISDN PRI function.
2) FIC-1E1-F/FIC-2E1-F/FIC-4E1-F
FIC-1E1-F/FIC-2E1-F/FIC-4E1-F, the 1-/2-/4-port fractional E1 interface module, differs from the
FIC-1E1/FIC-2E1/FIC-4E1 primarily in the sense that:
z
The FE1 operating mode supported by the E1-F modules allows only one n × 64 kbps bundle to be
formed on each interface, where n = 1 to 31. However, an E1 module allows arbitrary grouping of
31 channels and multiple bundles.
z
The FIC-E1-F modules do not support PRI mode.
Interface attributes
The following table describes the interface attributes of the FIC-E1 and FIC-E1-F modules.
Table 4-27 Interface attributes of the FIC-E1 and FIC-E1-F modules
Description
Attribute
FIC-1E1/FIC-1E1-F
FIC-2E1/FIC-2E1-F
FIC-4E1/FIC-4E1-F
Connector
DB-15 DB-15 DB-25
Number of
connectors
1 2 1
Interface standard
G.703, G.704
Interface rate
2.048 Mbps
Cable type
z
E1 75-ohm unbalanced coaxial cable
z
E1 120-ohm balanced twisted-pair cable
z
120-ohm 4E1 adapter cable (FIC-4E1/FIC-4E1-F)
z
75-ohm 4E1 adapter cable (FIC-4E1/FIC-4E1-F)
z
Coaxial connector, network connector, 75-to-120-ohm adapter (with BNC connector)
Operating mode
E1, CE1, ISDN PRI (only supported by the FIC-E1 modules)
FE1 (only supported by the FIC-E1-F modules)
Supported service
z
Backup
z
Leased line
z
ISDN PRI (only supported by the FIC-E1 modules)
Interface LEDs
The following figure illustrates the FIC-1E1 panel.