beautypg.com

Interface leds, Interface cable, Connecting the interface cable – H3C Technologies H3C MSR 50 User Manual

Page 59

background image

2-39

Attribute

DSIC-1SHDSL-8W

Interface standard

ITU-T G991.2 ANNEX A, ANNEX B, ANNEX F, ANNEX G
ITU-T G994.1 handshaking

Interface rate

z

5.69 Mbps (1 pair mode)

z

11.38 Mbps (2 pair mode)

z

17.07 Mbps (3 pair mode)

z

22.76 Mbps (4 pair mode)

Cable

Telephone cable with ferrite core (one RJ-45 connector converts to two
RJ-11 connectors.)

Operation mode

z

ATM

z

EFM

Supported services

G.SHDSL over the regular telephone line

Interface LEDs

The following figure illustrates the DSIC-1SHDSL-8W panel.

Figure 2-50 DSIC-1SHDSL-8W panel

The following table describes the LEDs on the module panel.

Table 2-29 LEDs on the DSIC-1SHDSL-8W panel

LED

Description

LINK/ACT (P0-P3)

z

ON means a carrier signal is received.

z

OFF means no carrier signals is received.

z

Fast blinking means data is being received or/and transmitted.

z

Slow blinking means the module is negotiating rates.

Interface cable

Figure 2-51 DSIC-1SHDSL-8W cable

Connecting the interface cable

Follow these steps to connect the DSIC-1SHDSL-8W cable:

Step1 Connect the RJ-45 connector of the cable to the G. SHDSL interface of the DSIC-1SHDSL-8W.

Step2 Connect the other end of the cable to its corresponding device.

This manual is related to the following products: