beautypg.com

Connecting the interface cable – H3C Technologies H3C MSR 50 User Manual

Page 145

background image

3-41

Figure 3-46 75-ohm 8E1 conversion cable

Figure 3-47 120-ohm 8E1 conversion cable

Connecting the interface cable

z

Before you connect a port, read its label carefully. A wrong connection can impair the interface
module and even damage the device.

z

You are recommended to install a special lightning arrester at the input end of the interface cable
for better lightning protection.

Step1 Choose an 8E1 conversion cable appropriate to the interface type of the peer device.

z

If the interface impedance of the peer device is 75-ohm, use a 75-ohm 8E1 conversion cable.

z

If the interface impedance of the peer device is 120-ohm, use a 120-ohm 8E1 conversion cable.

Step2 Insert the DB-68 connector of the cable to the DB-68 port on the MIM-8E1/MIM-8E1-F module, and

fasten the cable fastening screws.

Step3 Identify the sequence number of the other end of the MIM-8E1/MIM-8E1-F conversion cable and

connect it with a peer device.

This manual is related to the following products: