H3C Technologies H3C MSR 50 - Manual (Page 245)

4-50
FIC-1SHL-4W
Introduction
The 1-port dual-pair G.SHDSL interface module (FIC-1SHL-4W) provides a four-wire G.SHDSL
interface. It adopts TCPAM coding and provides symmetric rates up to 4.624 Mbps. The transmission
rate of the interface can automatically adapt to line distances and conditions.
Compared with ADSL, G.SHDSL allows farther transmission distance and thus has a wider application
scope. It is an alternative to E1/T1 line for high-speed data service access. However, as TCPAM uses
the band starting from 0 Hz for data transmission, G.SHDSL cannot share the same line with POTS or
ISDN like what ADSL has done.
The FIC-1SHL-4W has these features:
z
Supporting manual G.SHDSL line activation/deactivation and easy-to-use fault location tools.
z
Supporting G.992.1 interface standard and auto-sensing.
z
Allowing you to set the dual-pair G.SHDSL interface to operate in dual-pair or single-pair mode.
Interface attributes
Table 4-41 Interface attributes of the FIC-1SHL-4W
Attribute FIC-1SHL-4W
Connector RJ-11
Number of connectors 1
Interface standard
ITU-T G991.2
ITU-T G994.1 handshaking
Interface rate
z
In single-pair mode, supports the sending/receiving independent
symmetric rates in the range from 192 kbps to 2312 kbps in steps of 8
kbps.
z
In dual-pair mode, supports the sending/receiving independent
symmetric rates in the range from 384 kbps to 4624 kbps in steps of 16
kbps.
Interface cable Tailor-made 4-wire telephone cable
Supported services G.SHDSL over ordinary telephone lines
Interface LEDs
The following figure illustrates the FIC-1SHL-4W panel:
Figure 4-61 FIC-1SHL-4W panel
The following table describes the LEDs on the FIC-1SHL-4W panel.