beautypg.com

Mim-1vt1 module, Introduction – H3C Technologies H3C MSR 50 User Manual

Page 175

background image

3-71

z

Some measures are taken to protect MIM-1VE1 module. Still, you are recommended to install a
special lightning arrester at the input end of its connection cable to obtain better lightning protection
when the cable is led outdoors;

z

Read the mark identifying a port before connecting a cable to it, making sure it is the correct port.
Wrong connection tends to damage the MIM and even the router.

Step1 Plug the DB-15 connector of the cable into the DB-15 port on the MIM-1VE1 module and fasten the

screws;

Step2 Connect the RJ-45 connector of the cable to:

z

The peer device directly, if the resistance of the port to be connected is 120-ohm, and there is no
need to extend the cable;

z

A network interface connector and then the peer device using another E1 120-ohm balanced
twisted pair cable, if the resistance of the port to be connected is 120-ohm, and there is a need to
extend the cable, as illustrated in the following figure.

Figure 3-84 Extending E1 120-ohm balanced twisted pair cable

Router

Voice
Device

DB -15

Network interface

RJ-45

RJ-45

120-ohm balanced

120-ohm E1
trunk cable

twisted pair cable

connector

z

The peer device using a 75ohm-to-120ohm adapter, if the resistance of the peer device is 75-ohm;

Step3 Check the behavior of the LINK LED on the MIM-1VE1 panel. It is OFF when fault has occurred on the

link. In this case, please check the link.

MIM-1VT1 Module

Introduction

1-port T1 voice interface module (MIM-1VT1) can handle dense voice signals in VoIP system.

MIM-1VT1 module is structured in the form of board plus VCPM module plus VPM strip. It provides a
CT1/PRI port, allowing the access of 24 channels of voice signals.

This manual is related to the following products: