Interface attributes, Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 203
4-8
Interface attributes
The following table describes the interface attributes of the FIC-1GBE/FIC-2GBE:
Table 4-7 Interface attributes of the FIC-1GBE/FIC-2GBE
Attribute
FIC-1GBE
FIC-2GBE
Connector RJ-45
Number of connectors
1
2
Interface type
MDI/MDIX
Interface standard
802.3, 802.3u, and 802.3ab
Cable type
Ethernet cable
Operating mode
10/100/1000 Mbps auto-sensing
Half-duplex/full duplex, autosensing
Interface LEDs
The following figures show the FIC-1GBE and FIC-2GBE panels.
Figure 4-8 FIC-1GBE panel
Figure 4-9 FIC-2GBE panel
The following table describes the LEDs on the FIC-1GBE/FIC-2GBE panel.
Table 4-8 LEDs on the FIC-1GBE/FIC-2GBE panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACT
z
OFF means no data is being transmitted or received.
z
Blinking means data is being transmitted and/or received.
Interface cable
FIC-1GBE/FIC-2GBE uses both crossover and straight-through cables for connection.