Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 205
4-10
Attribute
FIC-1GEF
FIC-2GEF
Operating mode
1000 Mbps
Full duplex
Interface LEDs
The following figures illustrate the FIC-1GEF and FIC-2GEF panels:
Figure 4-11 FIC-1GEF panel
Figure 4-12 FIC-2GEF panel
The following table describes the LEDs on the FIC-1GEF and FIC-2GEF panels.
Table 4-10 LEDs on the FIC-1GEF/ FIC-2GEF panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACT
z
OFF means no data is being transmitted or received;
z
Blinking means data is being received or/and transmitted.
Interface cable
For FIC-1GEF and FIC-2GEF modules, select optical fibers depending on the type of the installed
1000Base-SX/1000 Base-LX SFP. Because the interfaces that these SFP modules provide use
LC-type fiber-optic connectors, you must use fibers with LC-type connectors for them.
Figure 4-13 LC-type fiber-optic connector