Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual
Page 282
4-87
z
VCPM is provided to users together with FIC-1VE1. Users can select VPM module as needed.
z
VPM module is installed on the main board of FIC-1VE1.
Interface attributes
The interface attributes of FIC-1VE1 are given in the following table.
Table 4-70 Interface attributes of FIC-1VE1
Attribute
Description
Connector DB-15
Number of connectors
1
Operating mode
CE1
ISDN PRI
R2
Interface rate
2.048 Mbps
Cable
z
E1 120-ohm balanced twisted pair cable
z
75ohm-to-120ohm adapter
z
Network interface connector
Supported service
z
R2 signaling
z
DSS1 signaling
z
IP Fax
z
General VoIP features in Comware
Interface LEDs
FIC-1VE1 panel is shown in the following figure:
Figure 4-111 FIC-1VE1 panel
Description of the LEDs on FIC-1VE1 panel is given in the following table:
Table 4-71 Description of the LEDs on FIC-1VE1 panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACTIVE
z
OFF means no data is being transmitted or received.
z
Blinking means there is data being transmitted or received.