beautypg.com

Connecting the interface cable – H3C Technologies H3C MSR 50 User Manual

Page 269

background image

4-74

Figure 4-96 FIC-24FXS conversion cable

You can connect the RJ-11 connectors to your cable distribution frame, or connect them to the phones
directly or after being prolonged.

Connecting the interface cable

Step1 Connect the D50 male connector on one end of the cable to the module.

Step2 Connect the RJ-11 connectors on the other end of the cable to telephones, Faxes or the AT0 loop

trunk lines of the telephone switchboards.

Make sure the screws at both sides of the FIC-24FXS module interface are tight.

This manual is related to the following products: