beautypg.com

Interface leds – H3C Technologies H3C MSR 50 User Manual

Page 29

background image

2-9

Attribute

Description

Frame format

z

Ethernet_II

z

Ethernet_SNAP

z

IEEE 802.2

z

IEEE 802.3

Operation mode

10/100/1000 Mbps autosensing
Full/half duplex

Network protocol

IP
Novell IPX

Table 2-8 Attributes of SFP module

SFP module name

Wavelength

Connector

Fiber specification

Maximum

transmission

distance

50/125 µm
multi-mode fiber

550 m (1804.5 ft.)

1000BASE-SX-SF
P

850 nm

62.5/125 µm
multi-mode fiber

275 m (902.2 ft.)

1000BASE-LX-SFP

10 km (6.2 mi.)

1000BASE-LH-SF
P

1310 nm

1000BASE-ZX-LR-
SFP

40 km (24.9 mi.)

1000BASE-ZX-VR-
SFP

70 km (43.5 mi.)

1000BASE-ZX-UR-
SFP

1550 nm

LC

9/125 µm
single-mode fiber

100 km (62.1 mi.)

SIC-1GEC uses COMBO interface; therefore it cannot support fiber and electrical interfaces at the
same time. When the router is powered on, the electrical interface takes effect by default. To use a fiber
interface, configure it at the command line interface (CLI).

Interface LEDs

The following figure illustrates the SIC-1GEC panel.

Figure 2-8 SIC-1GEC panel

This manual is related to the following products: