beautypg.com

Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual

Page 152

background image

3-48

Table 3-40 Interface attributes of 1CE3

Attribute

Description

Connector SMB

Number of connectors

2

Interface standard

G.703, G.704, G.751

Interface rate

34.368 Mbps

Interface cable type

E3 cable (75ohm coaxial cable)

Operating mode

E3
CE3

Supported service

E3 leased line

Interface LEDs

MIM-1CE3 panel is shown in the following figure:

Figure 3-55 MIM-1CE3 panel

The following table describes the LEDs on the MIM-1CE3 panel:

Table 3-41 Description of the LEDs on the MIM-1CE3 panel

LED

Description

LINK

z

OFF means the link is not set up.

z

ON means the link has been set up.

ACT

z

OFF means no data is being transmitted or received;

z

Blinking means data is being received or/and transmitted.

Interface cable

The external interface provided by a MIM-1CE3 module is two SMB sockets respectively for Tx
(Transmitter end) and Rx (Receiver end). The interface adopts 75ohm unbalanced transmission mode
and uses a pair of 75ohm unbalanced coaxial cables to connect the peer device.

Figure 3-56 E3/T3 cable

BNC connector

SMB connector

BNC connector

SMB connector

This manual is related to the following products: