beautypg.com

Interface leds – H3C Technologies H3C MSR 50 User Manual

Page 42

background image

2-22

Attribute

Description

Number of connectors

1

Interface standard

z

G.703/T1.102

z

G.704

z

AT&T TR 54016

z

AT&T TR 62411

z

ANSI T1.403

Interface rate

1.544 Mbps

Cable type

T1 cable (100-ohm standard shielded network cable)

Operating mode

CT1, ISDN PRI (supported by SIC-TPRI only)
FT1(supported by SIC-1T1-F only)

Supported service

z

Backup

z

Terminal access

z

ISDN (supported by SIC-TPRI only)

Interface LEDs

SIC-TPRI panel is shown in the following figure:

Figure 2-22 SIC-TPRI panel

SIC-1T1-F panel is shown in the following figure:

Figure 2-23 SIC-1T1-F panel

The status description of the LEDs is given in the following table:

Table 2-19 Description of the LEDs on SIC-TPRI/SIC-1T1-F panel

LED

Description

LINK/ACT

z

ON means the carrier signal has been received.

z

OFF means no carrier signal has been received.

z

Blinking means data is being transmitted or/and received.

LP/AL

z

ON means the interface is in a loopback.

z

Blinking means an AIS, LFA, or RAI alarm signal is present.

z

OFF means no loopback or alarm is present.

This manual is related to the following products: