H3C Technologies H3C MSR 50 - Manual (Page 287)

4-92
Interface attributes
The interface attributes of FIC-1VT1 are given in the following table.
Table 4-73 Interface attributes of FIC-1VT1
Attribute Description
Connector RJ-45
Number of connector 1
Interface standard
z
G.703/T1.102
z G.704
z AT&T TR 54016
z
AT&T TR 62411
z
ANSI T1.403
Interface rate 1.544 Mbps
Cable type T1 cable (100-ohm standard shielded cable)
Operation mode
z
CT1
z
ISDN PRI
Services
z
Backup
z
Terminal access
z ISDN
Interface LEDs
FIC-1VT1 panel is shown in the following figure:
Figure 4-117 FIC-1VT1 panel
Description of the LEDs on FIC-1VT1 panel is given in the following table:
Table 4-74 Description of the LEDs on FIC-1VT1 panel
LED Description
LINK
z
ON means carrier signal is received;
z
OFF means no carrier signal is received.
ACT
z
OFF: No data is being received and transmitted;
z Blinking: Data is being received and transmitted.
Interface cable
The interface cable of FIC-1VT1 is a standard 100-ohm standard shielding cable. The connectors on
the two ends use RJ 45. The following figure illustrates this type of cable.