Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual
Page 133
3-29
z
Up to 256 64 kbps logical channels
Interface attributes
The following table describes the interface attributes of MIM-1CPOS(E)/ MIM-1CPOS(T).
Table 3-28 Interface attributes of the MIM-1CPOS(E)/MIM-1CPOS(T) module
Attribute
MIM-1CPOS(E)/MIM-1CPOS(T)
Connector
SFP/LC
Number of
Connectors
1
Interface standard
SONET OC-3/SDH STM-1
Interface rate
155.52 Mbps
Type
Multi-mode
short-haul
Single mode
medium-haul
Single mode
long-haul
Single mode
ultra-long-haul
Min.
–19.0 dBm
–15.0 dBm
–5.0 dBm
–5.0 dBm
Optical
transmitt
er power
Max.
–14.0 dBm
–8.0 dBm
0. dBm
0. dBm
Receiver sensitivity
–30.0 dBm
–28.0 dBm
–34.0 dBm
–34.0 dBm
Overload optical
power
–14.0 dBm
–7.0 dBm
–9.0 dBm
–10.0 dBm
Central wavelength
1310 nm
1310 nm
1310 nm
1550 nm
Max. transmission
segment
2 km (1.2 mi.)
15 km (9.3 mi.)
40 km (24.9 mi)
80 km (49.7 mi)
Fiber type
62.5/125
μm
multi-mode
9/125 μm single
mode
9/125 μm single
mode
9/125 μm single
mode
For a long-haul fiber-optic interface, the transmission distance must be longer than 25 km (15.5 in.) to
allow the receiver to work. In case of closer distances, insert an optical attenuator to reduce the input
optical power.
Interface LEDs
The following figures illustrate the MIM-1CPOS(E) and MIM-1CPOS(T) panels:
Figure 3-31 MIM-1CPOS(E) front panel