beautypg.com

Interface cable – H3C Technologies H3C MSR 50 User Manual

Page 237

background image

4-42

Figure 4-52 FIC-2T1-F panel

The following figure illustrates the FIC-4T1-F panel.

Figure 4-53 FIC-4T1-F panel

The following table describes the LEDs on the module panels.

Table 4-34 LEDs on the FIC-T1 and FIC-T1-F panels

LED

Description

LINK/ACT

z

ON means the carrier signal has been received.

z

OFF means no carrier signal has been received.

z

Blinking means data is being transmitted or/and received.

LP/AL

z

ON means the interface is in a loopback.

z

Blinking means an AIS, LFA, or RAI alarm signal is present.

z

OFF means no loopback or alarm is present.

Note:
AIS = Alarm indication signal; LFA = loss of frame alignment; RAI = Remote alarm indication

Interface cable

Interface cables (T1 cables) for the FIC-T1/FIC-T1-F modules are 100-ohm straight-through shielded
cables, as shown in the following figure:

Figure 4-54 T1 cable

To extend a T1 cable, connect the cable to another one using a network interface connector with an
RJ-45 receptacle at each end.

This manual is related to the following products: