Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 201
4-6
Figure 4-4 FIC-1FE panel
The following figure illustrates a FIC-2FE panel.
Figure 4-5 FIC-2FE panel
The following figure illustrates a FIC-4FE panel.
Figure 4-6 FIC-4FE panel
The following table describes the LEDs on the FIC-1FE/FIC-2FE/FIC-4FE panel.
Table 4-6 LEDs on the FIC-1FE/FIC-2FE/FIC-4FE panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACTIVE
z
OFF means no data is being transmitted or received on the interface.
z
Blinking means data is being transmitted and/or received.
Interface cable
1) Ethernet
cable
As shown in the following figure, the Ethernet cables for FIC-FE modules are category-5 twisted pairs
with RJ-45 connectors. Pins 1 and 2 of the interface are used for transmitting data, and pins 3 and 6 are
used for receiving data.
Figure 4-7 Ethernet cable