Fic-8e1/fic-8e1-f, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual
Page 232: Interface leds
4-37
Step4 Connect the E1 cable to another device, by reference to the previous subsection.
Step5 Power on the router, and check the behavior of the LINK LED on the module panel: OFF means fault
occurs on the line and the signal is not synchronized. Check the line status.
FIC-8E1/FIC-8E1-F
Introduction
1) FIC-8E1
FIC-8E1, the 8-port channelized E1/PRI interface module, transmits, receives, and processes eight
channels of E1 data traffic. In addition, you can use the module for other purposes, such as CE1 access
and the ISDN PRI function.
2) FIC-8E1-F
FIC-8E1-F, the 8-port fractional E1 interface module, is different from the FIC-8E1 interface module in
the sense that:
z
The FE1 operating mode supported by the FIC-8E1-F module allows only one n × 64 kbps bundle
to be formed on each interface, where n = 1 to 31. However, a FIC-8E1 module allows arbitrary
grouping of 31 channels and therefore multiple bundles.
z
The FIC-8E1-F module does not support PRI mode.
Given a FIC-8E1 module, the system automatically creates a serial interface for each timeslot bundle
formed on a controller E1 interface.
Interface attributes
The following table describes the interface attributes of the FIC-8E1/FIC-8E1-F modules.
Table 4-31 Interface attributes of the FIC-8E1/FIC-8E1-F module
Description
Attribute
FIC-8E1/FIC-8E1-F (75-ohm)
FIC-8E1/FIC-8E1-F (120-ohm)
Connector DB-68
Number of connectors
1
Interface standard
G.703
Interface rate
2.048 Mbps
Cable type
75-ohm 8E1 conversion cable
120-ohm 8E1 conversion cable
Operating mode
z
E1, CE1, ISDN PRI (only supported by the FIC-8E1)
z
FE1 (only supported by the FIC-8E1-F)
Supported service
z
Backup
z
Terminal access service
z
ISDN PRI (only supported by the FIC-8E1)
Interface LEDs
FIC-8E1 and FIC-8E1-F panels are similar. The following figures illustrate the FIC-8E1 panels.