Mim-1gbe/mim-2gbe, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual
Page 116: Interface leds
3-12
Connect a cable to the port with the correct mark. Misplugging is prone to impair the SIC/MIM and even
damage the Router.
MIM-1GBE/MIM-2GBE
Introduction
1-port 10Base-T/100Base-TX/1000Base-T Ethernet electrical interface module (MIM-1GBE) and 2-port
10Base-T/100Base-TX/1000Base-T Ethernet electrical interface module serve to complete the
communication between a router and a LAN.
The GBE (Gigabit Ethernet) supports:
z
Transmission distance up to 100 meters over the category 5 twisted-pair cable;
z
Operating speeds of 1000 Mbps, 100 Mbps, and 10 Mbps, as well as auto-sensing;
z
Half-duplex/full duplex, autosensing
Interface attributes
The interface attributes of MIM-1GBE/MIM-2GBE are given in the following table:
Table 3-12 Interface attributes of MIM-1GBE/MIM-2GBE
Description
Attribute
MIM-1GBE
MIM-2GBE
Connector RJ-45
Number of connectors
1
2
Interface type
MDI/MDIX
Interface standard
802.3, 802.3u, 802.3ab
Cable type
Ethernet cable
Operating mode
10/100/1000 Mbps auto-sensing
Half-duplex/full duplex, autosensing
Interface LEDs
MIM-1GBE/MIM-2GBE panel is shown in the following figure:
Figure 3-13 MIM-1GBE panel