beautypg.com

Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual

Page 154

background image

3-50

Table 3-42 Interface attributes of MIM-1CT3

Attribute

Description

Connector SMB

Number of connectors

2

Interface standard

z

G.703

z

G.704

z

G.752

z

AT&T TR 54014

z

AT&T TR 62415

z

ANSI T1.107

Interface rate

44.736 Mbps

Interface cable type

T3 cable (75-ohm coaxial cable)

Operating mode

T3
CT3

Supported service

T3 leased line

Interface LEDs

MIM-1CT3 panel is shown in the following figure:

Figure 3-57 MIM-1CT3 panel

The following table describes the LEDs on the MIM-1CT3 panel:

Table 3-43 Description of the LEDs on the MIM-1CT3 panel

LED

Description

LINK/ACT

z

ON means the carrier signal has been received.

z

OFF means no carrier signal has been received.

z

Blinking means data is being transmitted or/and received.

LP/AL

z

ON means the interface is in a loopback.

z

Blinking means an AIS, LFA, or RAI alarm signal is present.

z

OFF means no loopback or alarm is present.

Note:
AIS = Alarm indication signal; LFA = loss of frame alignment; RAI = Remote alarm indication

Interface cable

z

MIM-1CT3 and MIM-1CE3 use the same type of interface cables and make connection in the same
way. For details, see the E3/T3 Interface Module.

This manual is related to the following products: