Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 74
2-54
The following figure illustrates the SIC-2BSV panel.
Figure 2-68 SIC-2BSV panel
The following table describes the LEDs on SIC-1BSV/SIC-2BSV panel.
Table 2-43 LEDs on SIC-1BSV/SIC-2BSV panel
LED
Description
B1
Green
Blinking indicates data is being transmitted or received on B1 channel.
B2
Green
Blinking indicates data is being transmitted or received on B2 channel.
ACT
Yellow
z
Blinking indicates the link is being activated.
z
Steady ON indicates the link is active.
ON
Green, power LED.
Steady ON indicates the module is powered on.
Interface cable
When a BSV interface works in user mode, it uses a straight-through ISDN S/T interface cable for
connection, with pins 3 and 6 for data transmission and pins 4 and 5 for data receiving. At both ends of
the cable are RJ-45 connectors.
Figure 2-69 Straight-through ISDN S/T cable
GreenYellow
RedBlack
Yellow
Green
Black
Red
GreenYellow
RedBlack
Yellow
Green
Black
Red
GreenYellow
RedBlack
Yellow
Green
Black
Red
GreenYellow
RedBlack
Yellow
Green
Black
Red
When a BSV interface works in network mode, it uses a crossover ISDN S/T interface cable for
connection, with pins 3 and 6 for data transmission and pins 4 and 5 for data receiving. At one end of the
cable is an RJ-45 plug for connecting the SIC-1BSV/SIC-2BSV interface and at the other end of the
cable is an RJ-45 receptacle for connecting a TE device.