beautypg.com

Interface leds, Interface cable, Connecting the interface cable – H3C Technologies H3C MSR 50 User Manual

Page 214

background image

4-19

Interface LEDs

The following figure illustrates the FIC-1AT3 panel:

Figure 4-23 FIC-1AT3 panel

The following table describes the LEDs on the FIC-1AT3 panel.

Table 4-18 LEDs on the FIC-1AT3 panel

LED

Description

LINK

z

OFF means no link is present;

z

ON means a link is present.

ACT

z

OFF means no data is being transmitted or received;

z

Blinking means data is being received or/and transmitted.

Interface cable

The interface that the FIC-1AT3 provides uses two SMB sockets for data transmitting and receiving
respectively. The ports adopt the 75-ohm unbalanced transmission mode and are connected to the
peer device using a pair of 75-ohm unbalanced coaxial cables as shown in

Figure 4-22

. Several cable

length options are available.

The FIC-1AT3 and FIC-1AE3 modules use the same type of cables for connection, which are called
E3/T3 cables in this manual.

Connecting the interface cable

By design, the FIC-1AT3 is protected against lightning strikes. But when outdoor cabling is involved,
you are recommended to add a special lightning arrester at the input end of the E3/T3 cable for better
protection.

Step1 Connect the SMB connector of an E3/T3 cable to the Tx port on the FIC-1AT3 and another end to the

Rx port on another device.

Step2 Connect the SMB connector of another E3/T3 cable to the Rx port on the FIC-1AT3 and another end

to the Tx port on another device.

This manual is related to the following products: