beautypg.com

Mim-1g.shdsl, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual

Page 157: Interface leds

background image

3-53

MIM-1G.SHDSL

Introduction

1-port Single-Pair High-Speed Digital Subscriber Line module (MIM-1G.SHDSL) adopts the Trellis
Coded Pulse Amplitude Modulation (TCPAM) approach and can provide the symmetric speed as high
as 2.3 Mbps. Its transmission speed can automatically adapt to cable length and conditions. Compared
with ADSL, G.SHDSL allows longer transmission distance and as such, can serve a wider range of
applications. It can substitute for E1/T1 lines to provide high-speed data service access. However, as
TCPAM uses the band starting from 0 Hz for data transmission, G.SHDSL cannot share the same line
with POTS or ISDN just like what ADSL has done.

The MIM-1G.SHDSL module supports:

z

Manual G.SHDSL line activation/deactivation and easy-to-use fault isolation tools;

z

G.992.1 interface standard and auto-sensing.

Interface attributes

The interface attributes of MIM-1G.SHDSL are given in the following table:

Table 3-46 Interface attributes of MIM-1G.SHDSL module

Attribute

MIM-1G.SHDSL module

Connector

RJ-11

Number of connectors

1

Interface standard

G.991.2

Interface rate

In single-pair mode, supports the sending/receiving independent
symmetric speed in the range 192 kbps to 2304 kbps, with the step
length being 8 kbps.

Cable

Telephone cable

Supported service

G.SHDSL access over telephone lines

Interface LEDs

MIM-1G.SHDSL panel is shown in the following figure:

Figure 3-61 MIM-1G.SHDSL panel

The following table describes the LEDs on the MIM-1G.SHDSL panel:

Table 3-47 Description of the LEDs on the MIM-1G.SHDSL panel

LED

Description

LINK

z

OFF means no link is present;

z

ON means a link is present.

ACT

z

OFF means no data is being transmitted or received;

z

Blinking means data is being received or/and transmitted.

This manual is related to the following products: