beautypg.com

Interface cable – H3C Technologies H3C MSR 50 User Manual

Page 198

background image

4-3

On the FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE panel, each port on the
network connector corresponds to one green LED. The following table describes the LEDs on the
FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE panel.

Table 4-2 LEDs on the FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE FE interface

LED

Description

Steady green

A link is present, but no data is being transmitted and received.

OFF

No link is present.

Blinking green

A link is present and data is being transmitted and received (ACT).

The following table describes the LEDs on the GE port and SFP fiber interface:

Table 4-3 LEDs on the FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE GE interface

LED

Description

OFF

No link is present.

Steady green

A 1000 Mbps link is present, but no data is being transmitted and received.

Blinking green

A 1000 Mbps link is present and data is being transmitted and received (ACT).

Steady yellow

A 100 Mbps link is present, but no data is being transmitted and received.

Blinking yellow

A 100 Mbps link is present and data is being transmitted and received (ACT).

Table 4-4 LEDs on the FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE fiber interface

LED

Description

OFF

No link is present.

Steady green

A link is present, but no data is being transmitted and received.

Blinking green

A link is present and data is being transmitted and received (ACT).

Steady yellow

Error prompt

In addition, there is a POE LED on each module, which is provided for the corresponding boards
(FIC-16FSW-PoE and DFIC-24FSW-PoE) with the PoE function.

The two GE interfaces on the DFIC-24FSW-PoE do not support the PoE function.

Interface cable

Typically, category-5 twisted pair cable is adopted to connect the 10BASE-T /100BASE-TX Ethernet
interface to the Ethernet, as shown in the following figure:

This manual is related to the following products: