Removing a mim, Installing/removing a fic, Tools required – H3C Technologies H3C MSR 50 User Manual
Page 18
1-9
Figure 1-3 Installing a MIM (1)
Figure 1-4 Installing a MIM (2)
Removing a MIM
Follow these steps to remove a MIM:
Step1 Place the rear panel of the Router towards you;
Step2 Turn off the power switch of the Router and unplug the power cord;
Step3 Unplug all interface cables from the rear panel of the Router;
Step4 Loosen the captive screws at both sides of the MIM;
Step5 Pull the MIM towards you until it is completely separated from the bottom of the router.
Installing/Removing a FIC
z
The EMI gaskets on the FIC panel can filter electromagnetic interference of the router. Do not
damage them when uninstalling or replacing an FIC.
z
If you do not install a new FIC after removing the old one, replace the blank filter panel to keep off
the dust and ensure adequate ventilation of the router.
Tools required
z
ESD-preventive wrist strap