beautypg.com

Interface cable, Interface cable of fxs/fxo modules, Interface cable of e&m modules – H3C Technologies H3C MSR 50 User Manual

Page 182

background image

3-78

Figure 3-94 MIM-4FXS panel

ACT

LINK

Figure 3-95 MIM-4FXO panel

ACT

LINK

Figure 3-96 MIM-4E&M panel

ACT

LINK

Table 3-66 Description of the LEDs on voice MIM panels

LED

Description

LINK

z

OFF means no link is present; ON means a link is present.

ACT

z

OFF means the channel is idle. ON means there is call activity.

Interface cable

z

RJ-45 receptacles are used as external interfaces for FXS/FXO/E&M modules.

z

Telephone cables have been included in the standard shipment package of MIM-2FXS/MIM-2FXO
and MIM-4FXS/MIM-4FXO modules.

Interface cable of FXS/FXO modules

Connection cables for MIM-2FXS/MIM-2FXO and MIM-4FXS/MIM-4FXO are telephone cables with
ferrite core. For cable pinouts, see Low-End and Mid-Range Series Routers Cable Manual.

Interface cable of E&M modules

E&M modules of H3C Series Routers support Bell I, II, III, V switches, and 2-wire & 4-wire voice signals.

It is recommended to use Bell V 4-wire voice signal to communicate with the Router in practice.

The sequence of E&M RJ-45 pins is shown in the following figure, numbered 1 to 8 from left to right:

This manual is related to the following products: