beautypg.com

Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual

Page 181

background image

3-77

z

2/4-port voice E&M analog trunk interface module (MIM-2E&M/MIM-4E&M) serves to access and
handle 2/4 channels of E&M analog trunks.

These modules make it possible to transfer voice signals over data communication networks.

Interface attributes

The interface attributes of MIM-2FXS/MIM-2FXO/MIM-2E&M and MIM-4FXS/MIM-4FXO/MIM-4E&M
modules are given in the following table:

Table 3-65 Interface attributes of MIM-2FXS/MIM-2FXO/MIM-2E&M and

MIM-4FXS/MIM-4FXO/MIM-4E&M

Attribute

Description

Connector RJ-45

Number of connectors

z

2 (MIM-2FXS/MIM-2FXO/MIM-2E&M module)

z

4 (MIM-4FXS/MIM-4FXO/MIM-4E&M module)

Cable

z

Telephone cable with ferrite core

z

E&M trunk (for E&M module, which should be made by users depending
on the actual needs at the site.)

Interface standard

z

ITU Q.512-compliant subscriber circuit interface (MIM-2FXS/MIM-4FXS)

z

ITU Q.552-compliant loop trunk interface (MIM-2FXO/MIM-4FXO)

z

G.712-compliant E&M trunk interface (MIM-2E&M/MIM-4E&M), E&M
interface (supporting Bell type I, II, III, V, and support 2-wire and 4-wire).

z

ITU K.20-compliant overcurrent and overvoltage protection

Dial-up mode

DTMF (Dual-Tone Multi-Frequency) but not pulse dial-up

Bandwidth

300 Hz to 3400 Hz

Interface LEDs

Voice MIM panels are shown in the following figures:

Figure 3-91 MIM-2FXS panel

ACT

LINK

Figure 3-92 MIM-2FXO panel

ACT

LINK

Figure 3-93 MIM-2E&M panel

ACT

LINK

This manual is related to the following products: