beautypg.com

Interface cable, Connecting the interface cable – H3C Technologies H3C MSR 50 User Manual

Page 240

background image

4-45

Table 4-36 LEDs on FIC-8T1 and FIC-8T1-F panels

LED

Description

LINK

z

OFF means no link is present;

z

ON means a link is present.

ACTIVE

z

OFF means no data is being transmitted or received.

z

ON means data is being transmitted and/or received.

Interface cable

The following figure illustrates the 8T1 conversion cable for the FIC-8T1/FIC-8T1-F module.

Figure 4-57 8T1 conversion cable

At one end of the cable is a DB-68 connector for connecting the router and at the other end are eight
RJ-45 connectors for connecting other devices.

Connecting the interface cable

Before you connect a port, read its label carefully; a wrong connection can impair the interface module
and even damage the device.

If the interface cable is routed outdoors, you are recommended to install a special lightning arrester at
the input end of the interface cable for better lightning protection.

Step1 Insert the DB-68 connector of the 8T1 conversion cable to the DB-68 port on the FIC-8T1/FIC-8T1-F

module.

Step2 Connect one RJ-45 connector at the other end of the cable to the device to be connected.

Step3 Power on the router. Check the behavior of the LINK LED on the module panel: OFF means fault

occurs on the line. Check the line status.

This manual is related to the following products: