Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 123
3-19
Table 3-18 Interface attributes of MIM-1AE3
Attribute
1AE3 module
Connector SMB
Connector number
2
Interface standard
G.703, G.751, G.832, G.823
Interface rate
34.368 Mbps
Cable
E3/T3 cable (75-ohm coaxial cables)
Supported service
ATM Traffic CBR, rt_VBR, nrt_VBR, UBR
In the supported services described in the above table, CBR represents Constant Bit Rate, rt_VBR
represents Variable Bit Rate-Real Time, nrt_VBR represents Variable Bit Rate-Non Real Time, and
UBR represents Unspecified Bit Rate.
Interface LEDs
MIM-1AE3 panel is shown in the following figure:
Figure 3-20 MIM-1AE3 panel
The following table describes the LEDs on the MIM-1AE3 panel:
Table 3-19 Description of the LEDs on the MIM-1AE3 panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACT
z
OFF means no data is being transmitted or received.
z
Blinking means data is being received or/and transmitted.
Interface cable
External ports provided by MIM-1AE3 are two SMB sockets respectively functioning as Tx end and Rx
end for transmitting data and receiving data. The ports work in 75-ohm unbalanced transmission mode
and are connected to the peer device using a pair of 75-ohm unbalanced coaxial cables. Several cable
length options are available.