beautypg.com

Interface cable – H3C Technologies H3C MSR 50 User Manual

Page 226

background image

4-31

Figure 4-36 FIC-4E1-F panel

The following table describes the LEDs on the module panels.

Table 4-28 LEDs on the FIC-E1 and FIC-E1-F panels

LED

Description

LINK

z

ON means the carrier signal has been received.

z

OFF means no carrier signal has been received.

ACTIVE

z

OFF means no data is being transmitted or received on the interface.

z

Blinking means data is being transmitted and/or received.

Interface cable

1) Interface cable of the FIC-1E1/FIC-2E1 and the FIC-1E1-F/FIC-2E1-F

Interface cables for the FIC-1E1/FIC-2E1 and FIC-1E1-F/FIC-2E1-F are G.703-compliant cables, also
known as E1 cables. The cables are divided into two categories: 75-ohm unbalanced coaxial and
120-ohm balanced twisted-pair.

z

75-ohm unbalanced coaxial cable

As shown in the following figure, at the router end of the cable is a DB-15 plug and at the network end
are two BNC receptacles.

Figure 4-37 E1 75-ohm unbalanced coaxial cable

To extend an E1 75-ohm unbalanced coaxial cable, select a pair of coaxial connectors with a BNC
receptacle at each end to connect the BNC receptacles of the cable each to a 75-ohm unbalanced
coaxial cable with BNC connectors.

z

120-ohm balanced twisted-pair cable

As shown in the following figure, at the router end of the cable is a DB-15 plug and at the network end
is an RJ-45 connector.

This manual is related to the following products: