Mim-8fxs8fxo, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual
Page 169: Interface leds
3-65
z
MIM-1VE1
z
MIM-1VT1
MIM-8FXS8FXO
Introduction
The 8-port voice subscriber circuit and 8-port voice AT0 analog trunk interface module
(MIM-8FXS8FXO) serves to access and handle 16 channels of analog voice signals over data
communication networks. The module provides eight FXS interfaces and eight FXO interfaces:
z
FXS interfaces are analog subscriber line interfaces that provide ordinary analog telephone and fax
access and also can connect AT0 loop trunks of exchanges.
z
FXO interfaces are loop trunk interfaces that provide access of common subscriber lines of
exchanges.
While using MIM-8FXS8FXO, make sure that the device can be connected to IP networks or other
WANs.
Interface attributes
The following table describes the interface attributes of the MIM-8FXS8FXO module:
Table 3-55 Interface attribute of MIM-8FXS8FXO
Attribute
Description
Connector type
RJ-11
Number of connectors
z
8 (FXS interfaces)
z
8 (FXO interfaces)
Interface standard
z
Subscriber circuit interface (FXS) compliant with ITU Q.512.
z
Loop trunk interface (FXO) compliant with ITU Q.552.
z
Over-current and over-voltage protection compliant with ITU K.20.
Cable type
Telephone cable with ferrite core
Dial-up mode
DTMF, compliant with GB3378 (Pulse dial-up is not available.)
Bandwidth
300 to 3400 Hz
Interface LEDs
The following figure illustrates the MIM-8FXS8FXO panel.