Interface attributes, Interface leds, Interface optical fiber – H3C Technologies H3C MSR 50 User Manual
Page 217
4-22
z
155.52 Mbps fractional interface
Interface attributes
The following table describes the interface attributes of the FIC-1POS.
Table 4-21 Interface attributes of the FIC-1POS
Attribute
FIC-1POS
Connector
SFP/LC
Interface standard
SONET OC-3/SDH STM-1
Number of
interfaces
1
Interface rate
155.52 Mbps
Type
Multi-mode
short-haul
Single mode
medium-haul
Single mode
long-haul
Single mode
ultra-long haul
Min.
–19.0 dBm
–15.0 dBm
–5.0 dBm
–5.0 dBm
Optical
transmitt
er power
Max.
–14.0 dBm
–8.0 dBm
0. dBm
0. dBm
Receiver sensitivity
–30.0 dBm
–28.0 dBm
–34.0 dBm
–34.0 dBm
Overload optical
power
–14.0 dBm
–7.0 dBm
–9.0 dBm
–10.0 dBm
Central wavelength
1310 nm
1310 nm
1310 nm
1550 nm
Fiber type
62.5/125
μm
multi-mode
9/125 μm single
mode
9/125 μm single
mode
9/125 μm single
mode
Max. transmission
segment
2 km (1.2 mi.)
15 km (9.3 mi.)
40 km (24.9 mi)
80 km (49.7 mi)
Interface LEDs
The following figure illustrates the FIC-1POS panel:
Figure 4-25 FIC-1POS panel
The following table describes the LEDs on the FIC-1POS panel.
Table 4-22 LEDs on the FIC-1POS panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACT
z
OFF means no data is being transmitted or received;
z
Blinking means data is being received or/and transmitted.
Interface optical fiber
Like the FIC-1CPOS, the FIC-1POS uses optical fibers with LC-type connectors.