beautypg.com

Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual

Page 144

background image

3-40

Description

Attribute

MIM-8E1/MIM-8E1-F module (75-ohm)

MIM-8E1/MIM-8E1-F module

(120-ohm)

Number of connectors

1

Interface standard

G.703

Interface rate

2.048 Mbps

Cable type

75-ohm 8E1 conversion cable

120-ohm 8E1 conversion cable

Cable characteristic
impedance

75-ohm 120-ohm

Operating mode

E1, CE1, ISDN PRI (only supported by MIM-8E1)
FE1 (only supported by MIM-8E1-F)

Supported service

z

Backup

z

Terminal access service

z

ISDN PRI (only supported by MIM-8E1)

Interface LEDs

MIM-8E1 and MIM-8E1-F panels are similar. The following figures illustrate MIM-8E1 panels.

Figure 3-44 MIM-8E1 (120-ohm) panel

Figure 3-45 MIM-8E1 (75-ohm) panel

The following table describes the LEDs on the MIM-8E1/MIM-8E1-F panel:

Table 3-35 Description of the LEDs on the MIM-8E1/MIM-8E1-F panel

LED

Description

LINK

z

OFF means no link is present;

z

ON means a link is present.

ACTIVE

z

OFF means no data is being transmitted or received.

z

ON means data is being transmitted or received.

Interface cable

The MIM-8E1/MIM-8E1-F module provides eight E1 ports and adopts a 120-ohm or a 75-ohm 8E1
conversion cable. The two types of cables look similar. Both of them have a DB-68 connector at one end
for connecting the router. At the other end, however, the 75-ohm 8E1 conversion cable provides 16
coaxial cable connectors; and the 120-ohm 8E1 conversion cable provides eight twisted pair cable
connectors, as shown in the following figures:

This manual is related to the following products: