beautypg.com

Connecting the interface cable, Fic-1gef/fic-2gef, Introduction – H3C Technologies H3C MSR 50 User Manual

Page 204: Interface attributes

background image

4-9

Figure 4-10 Ethernet cable

Connecting the interface cable

Step1 Connect one end of the cable to the Ethernet interface on the router and the other end to another

device.

Step2 Power on the router and check the behavior of the LINK LED on the panel. ON means a link is present

and OFF means no link is present. In the latter case, check the line status.

FIC-1GEF/FIC-2GEF

Introduction

FIC-1GEF/FIC-2GEF, the 1-port/2-port 1000Base-SX/1000Base-LX GE optical interface module, is
used for router-to-LAN communication.

The modules support:

z

Five types of 1000Base-SX/1000Base-LX SFP modules: multi-mode short-haul (850 nm),
single-mode medium-haul (1310 nm), single-mode long-haul (1310 nm), single mode long-haul
(1550 nm), and single-mode ultra-long haul (1550 nm)

z

Operation at 1000 Mbps

z

Full duplex

Interface attributes

The following table describes the interface attributes of the FIC-1GEF/FIC-2GEF:

Table 4-9 Interface attributes of the FIC-1GEF/FIC-2GEF

Attribute

FIC-1GEF

FIC-2GEF

Connector

SFP

Number of
interfaces

1 2

Interface standard

802.3, 802.3u, 802.3ab

Type

Multi-mode
short-haul
(850 nm)

Single-mode
medium-haul
(1310 nm)

Long-haul
(1310 nm)

Long-haul
(1550 nm)

Ultra-long haul
(1550 nm)

Min.

–9.5 dBm

–9 dBm

–2 dBm

–4 dBm

–4 dBm

Optical
transmitt
er power

Max.

0 dBm

–3 dBm

5 dBm

1 dBm

2 dBm

Receiver sensitivity

–17 dBm

–20 dBm

–23 dBm

–21 dBm

–22 dBm

Central wavelength

850 nm

1310 nm

1310 nm

1550 nm

1550 nm

Fiber type

62.5/125 μm
multi-mode

9/125

μm

single mode

9/125

μm

single mode

9/125

μm

single mode

9/125 μm single
mode

Max. transmission
segment

0.55 km (0.34
mi.)

10 km (6.21
mi.)

40 km (24.86
mi.)

40 km (24.86
mi.)

70 km (43.50 mi.)

This manual is related to the following products: