Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 191
3-87
Figure 3-105 MIM-16ASE panel
Each channel on MIM-8ASE/MIM-16ASE has only one LED. The following table describes the LEDs on
the panel.
Table 3-73 Description of the LEDs on the MIM-8ASE/MIM-16ASE panel
LED
Description
LINK
z
OFF means no link is present;
z
ON means a link is present.
ACTIVE
z
OFF means no data is being transmitted or received.
z
Blinking means data is being transmitted or received.
Interface cable
Three types of interface cables can be connected to the MIM-8ASE/MIM-16ASE and reach three types
of peer devices.
z
If the peer device is a transmission device and provides an RJ-45 interface, use a straight-through
cable to connect it to the MIM-8ASE/MIM-16ASE.
Figure 3-106 Ethernet cable
This cable is optional. You need to order it when purchasing a MIM-8ASE/MIM-16ASE.
z
If the peer device is a dumb terminal and provides an RJ-45 interface, use a dumb terminal cable to
connect it to the MIM-8ASE/MIM-16ASE. The two ends of the dumb terminal cable are male and
female RJ-45 connectors. Connect the male RJ-45 connector to the MIM-8ASE/MIM-16ASE, and
the female RJ-45 connector to the dumb device through a straight-through cable.