Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 89
2-69
Attribute
Description
Cable type
TNC RF: None
RJ-45: AUX cable
Rates
Network standards:
z
1 × EV-DO Rev.A (Downlink: 3.1 Mbps, uplink: 1.8 Mbps)
z
1 × EV-DO Rev.0 (Downlink: 2.4 Mbps, uplink: 153.6 Kbps)
z
1 × RTT (Downlink: 153.6 Kbps, uplink: 153.6 Kbps)
Services
z
CDMA 2000 1x RTT
z
1 × EV-DO Rev.0
z
1 × EV-DO Rev.A
Interface LEDs
SIC-3G-CDMA panel is shown in the following figure:
Figure 2-85 SIC-3G-CDMA panel
The following table describes the LEDs on the SIC-3G-CDMA panel:
Table 2-56 Description of the LEDs on the SIC-3G-CDMA panel
LED
Description
WWAN
z
Steady green indicates that a link is present.
z
Blinking green indicates that data is being transmitted or received.
RSSI
z
Steady green indicates strong signal.
z
Blinking green indicates middle or low signal.
z
OFF indicates weak signal or no signal.
1xRTT
z
Steady yellow indicates the service is valid.
z
OFF indicates no service.
EVDO
z
Steady yellow indicates the service is valid.
z
OFF indicates no service.
Interface cable
1) TNC
antenna
The TNC interface on the SIC-3G-CDMA uses a rod-shaped antenna, magnetic antenna, or ceiling
mount antenna for connection.
z
Rod-shaped antenna