beautypg.com

Ethernet interface module, Fic-1fe/fic-2fe/fic-4fe, Introduction – H3C Technologies H3C MSR 50 User Manual

Page 200: Interface attributes, Interface leds

background image

4-5

Step1 (Use a crossover cable for the connection to a PC/router and straight-through cable to a Hub/LAN

Switch.) Plug one end of the cable to an Ethernet port of the Router and another end to the desired
peer device;

Step2 Check the status of LINK LED on the FE module panel: ON means the link is connected and OFF

means the link is not connected. In the latter case, check the line.

Ethernet Interface Module

z

FIC-1FE

z

FIC-2FE

z

FIC-4FE

z

FIC-1GBE

z

FIC-2GBE

z

FIC-1GEF

z

FIC-2GEF

FIC-1FE/FIC-2FE/FIC-4FE

Introduction

The 1-port, 2-port, and 4-port 10Base-T/100Base-TX fast Ethernet interface modules (FIC-1FE,
FIC-2FE, and FIC-4FE) are mainly used for the communication between the router and LAN.

The modules support:

z

100 meters (328.1 ft.) of transmission segment over the category-5 twisted-pair cable.

z

Operation at 100 Mbps and 10 Mbps, autosensing.

z

Full duplex and half-duplex, with the former in common use.

Interface attributes

The following table describes the interface attributes of the FIC-1FE/FIC-2FE/FIC-4FE modules.

Table 4-5 FIC-1FE/FIC-2FE/FIC-4FE interface attributes

Description

Attribute

FIC-1FE

FIC-2FE

FIC-4FE

Connector

RJ-45

Number of connectors

1 2 4

Cable

Straight-through Ethernet cable

Operating mode

Full duplex/half-duplex
10/100 Mbps auto-sensing

Supported frame format

Ethernet_II
Ethernet_SNAP

Interface LEDs

The following figure illustrates a FIC-1FE panel.

This manual is related to the following products: