Interface attributes, Interface leds, Interface cable – H3C Technologies H3C MSR 50 User Manual
Page 257
4-62
Interface attributes
The following table describes the interface attributes of the FIC-8ASE and FIC-16ASE:
Table 4-51 Interface attributes of the FIC-8ASE/ FIC-16ASE
Description
Attribute
FIC-8ASE
FIC-16ASE
Connector RJ-45
Number of connectors
z
8 (FIC-8ASE)
z
16 (FIC-16ASE)
Interface standard and operating mode
RS232
Cable type
z
AUX cable
z
Ethernet straight-through cable
z
FIC-8ASE/FIC-16ASE dumb terminal cable
Min. baud rate (bps)
300
Max. baud rate (bps)
115.2 k
Service supported
z
Dialup through modem
z
Backup
z
Terminal access service
z
Asynchronous leased line
Interface LEDs
The following figures show the FIC-8ASE and FIC-16ASE panels:
Figure 4-81 FIC-8ASE panel
Figure 4-82 FIC-16ASE panel
The FIC-8ASE/FIC-16ASE has one LED for each port. These LEDs are located in the apertures
beneath the ports. ON means a link is present; OFF means data is being transmitted and/or received.
Interface cable
The FIC-8ASE/FIC-16ASE uses two types of interface cables: AUX cable and dumb terminal cable
(RJ-45-to-RJ-45), which can be made on site with network cables.