beautypg.com

Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual

Page 146

background image

3-42

Step4 Power on the router. Check the behavior of the LINK LED on the module panel. It is OFF when fault

has occurred on the link and signal is out of synchronization. In this case, please check the link.

MIM-1T1/MIM-2T1/MIM-4T1/MIM-1T1-F/MIM-2T1-F/MIM-4T1-F

Introduction

1) MIM-1T1/MIM-2T1/MIM-4T1

1/2/4-port channelized T1/PRI interface module (MIM-1T1/MIM-2T1/MIM-4T1) serves to
transmit/receive and handle T1 data streams, provide CT1 access, and fulfill the function of ISDN PRI.
Thereby, one module can be used for multiple purposes.

2) MIM-1T1-F/MIM-2T1-F/MIM-4T1-F

1/2/4-port fractional T1 interface module (MIM-1/2/4T1-F) and MIM-1/2/4T1 module are different in the
sense that:

z

FT1 operating mode supported by T1-F modules allows only one bundle. In other words, the time
slots can only be bundled into one nx64 kbps or 56 kbps channel, where n=1-24. However, a CT1
module allows of arbitrary grouping of the 24 channels;

z

T1-F does not support PRI mode.

Given a MIM-1T1 module, the system automatically creates a serial interface for each timeslot bundle
formed on a controller T1 interface.

Interface attributes

The interface attributes of MIM-1T1/MIM-2T1/MIM-4T1 and MIM-1T1-F/MIM-2T1-F/MIM-4T1-F
modules are given in the following table:

Table 3-36 Interface attributes of MIM-1T1/MIM-2T1/MIM-4T1 and MIM-1T1-F/MIM-2T1-F/MIM-4T1-F

modules

Attribute

Description

Connector RJ-45

Number of connectors

z

1 (MIM-1T1/MIM-1T1-F module)

z

2 (MIM-2T1/MIM-2T1-F module)

z

4 (MIM-4T1/MIM-4T1-F module)

Interface standard

z

G.703/T1.102

z

G.704

z

AT&T TR 54016

z

AT&T TR 62411

z

ANSI T1.403

Interface rate

1.544 Mbps

Cable type

T1 cable (100-ohm shielding network cable)

Operating mode

CT1, ISDN PRI (MIM-1T1/MIM-2T1/MIM-4T1 module)
FT1 (MIM-1T1-F/MIM-2T1-F/MIM-4T1-F module)

This manual is related to the following products: