Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual
Page 121
3-17
For how to configure ATM interfaces, see H3C MSR Series Routers User Manual.
Interface attributes
The following table describes the interface attributes of the MIM-1ATM-OC3 module:
Table 3-16 Interface attributes of MIM-1ATM-OC3
Attribute
MIM-1ATM-OC3
Number of
interfaces
1
Connector SFP/LC
Interface
standard
SONET OC-3/SDH STM-1
Type
Multi-mode
short-haul (850
nm)
Single mode
medium-haul
(1310 nm)
Long-haul
(1310 nm)
Long-haul
(1550 nm)
Ultra-long
(1550 nm)
Min.
–9.5 dBm
–9 dBm
–2 dBm
–4 dBm
–4 dBm
Transm
itting
optical
power
Max.
0 dBm
–3 dBm
5 dBm
1 dBm
2 dBm
Receiver
sensitivity
–17 dBm
–20 dBm
–23 dBm
–21 dBm
–22 dBm
Central
wavelength
850 nm
1310 nm
1310 nm
1550 nm
1550 nm
Fiber type
62.5/125 μm
multi-mode
9/125 μm single
mode
9/125 μm single
mode
9/125 μm single
mode
9/125 μm single
mode
Max.
transmission
segment
0.55 km (0.34
mi.)
10 km (6.21 mi.)
40 km (24.86
mi.)
40 km (24.86
mi.)
70 km (43.50
mi.)
Operating mode
1000 Mbps
Full-duplex
Interface LEDs
MIM-1ATM-OC3 panel is shown in the following figure:
Figure 3-19 MIM-1ATM-OC3 panel
The following table describes the LEDs on the MIM-1ATM-OC3 panel.