Sic-1vt1, Introduction, Interface attributes – H3C Technologies H3C MSR 50 User Manual
Page 81: Interface leds
2-61
SIC-1VT1
Introduction
1-port T1 voice interface module (SIC-1VT1) can handle dense voice signals in VoIP system. It provides
a CT1/PRI/R2 port, allowing the access of 23 channels of voice signals.
z
When purchasing a SIC-1VT1 interface module, users should purchase a VCPM and configure a
VPM based on voice traffic.
z
No VCPM is required, but only a VPM needs to be installed on the main board when MSR 20-1x
series routers need to be equipped with a SIC-1VT1 interface module.
z
VCPM and VPM need to be installed on the main board when MSR 30 series routers need to be
equipped with a SIC-1VT1 interface module.
z
VCPM and VPM need to be installed on the MSCA module when MSR 50 series routers need to be
equipped with a SIC-1VT1 interface module.
Interface attributes
Table 2-47 Interface Attributes of the SIC-1T1-F
Attribute
Description
Connector RJ-45
Number of connector
1
Interface standard
z
G.703/T1.102
z
G.704
z
AT&T TR 54016
z
AT&T TR 62411
z
ANSI T1.403
Interface rate
1.544 Mbps
Cable type
T1 cable (100-ohm standard shielded cable)
Operation mode
CT1
ISDN PRI
Services
Backup
Terminal access
ISDN
Interface LEDs
The following figure illustrates the SIC-1VT1 panel.