H3C Technologies H3C MSR 50 - Manual (Page 258)

4-63
AUX cables are optional and are provided only when ordered. As for dumb terminal cables, you can
make on site by reference to Low-End-and-Mid-Range Series Routers Cable Manual.
Connecting the interface cable
z
Do not plug or unplug interface cables into or from the FIC-8ASE/FIC-16ASE module to prevent
the device or ports from being impaired.
z
Before you connect a port, read its label carefully. A wrong connection can cause damages to the
interface module and even the device.
Step1 Identify type of the interface to be connected and then select the correct cable.
Step2 Make connection as follows:
z
If an AUX cable is used,
Connect the RJ-45 connector of the cable to the router and the DB-25/DB-9 connector to the network
device, usually a modem.
z
If a dumb terminal cable is used,
Connect its RJ-45 connector (female) to a straight-through cable and then to a dumb terminal adapter.
Figure 4-83 Connect the FIC-8ASE/ FIC-16ASE cable to a dumb terminal
Standard
network cable
Dumb
Dumb terminal adapter
8ASE/16ASE dumb
terminal cable
Standard
network cable
adapter
Dumb terminal adapter
8ASE/16ASE dumb
terminal cable
Router
Standard
network cable
Dumb
Dumb terminal adapter
8ASE/16ASE dumb
terminal cable
Standard
network cable
adapter
Dumb terminal adapter
8ASE/16ASE dumb
terminal cable
Router
Step3 Power on the router, and check behavior of the LINK LED on the FIC-SAE module: ON means a link is
present and OFF means no link is present. Check the line for the cause in the latter case.
POS Terminal Access Interface Module
z
FIC-6FCM
FIC-6FCM
Introduction
The 6-port fast connect modem interface module (FIC-6FCM) provides services for point of sale (POS)
terminal devices to fast dial up to a bank card accounting system.