beautypg.com

Interface attributes, Interface leds – H3C Technologies H3C MSR 50 User Manual

Page 239

background image

4-44

z

The FT1 operating mode supported by the FIC-8T1-F module allows only one n × 64 kbps or n ×
56 kbps bundle to be formed on each interface, where n = 1 to 24. However, the FIC-8T1 module
allows arbitrary grouping of 24 channels and therefore multiple bundles.

z

The FIC-8T1-F module does not support PRI mode.

Given a FIC-8T1 module, the system automatically creates a serial interface for each timeslot bundle
formed on a controller T1 interface.

Interface attributes

The following table describes the interface attributes of the FIC-8T1/FIC-8T1-F module.

Table 4-35 LEDs on the FIC-8T1 and FIC-8T1-F panels

Attribute

Description

Connector RJ-45

Number of connectors

1

Interface standard

z

G.703/T1 102

z

G.704

z

AT&T TR 54016

z

AT&T TR 62411

z

ANSI T1.403

Interface rate

1.544 Mbps

Cable type

8T1 conversion cable (100-ohm straight-through shielded network cable)

Operating mode

z

CT1, ISDN PRI (only supported by the FIC-8T1)

z

FT1 (only supported by the FIC-8T1-F)

Supported service

z

Backup

z

Terminal access service

z

ISDN PRI (supported by the FIC-8T1)

Interface LEDs

FIC-8T1 and FIC-8T1-F panels look the same. The following figure illustrates a FIC-8T1 panel.

Figure 4-56 FIC-8T1 panel

The following table describes the LEDs on the module panels:

This manual is related to the following products: