H3C Technologies H3C MSR 50 - Manual (Page 281)

4-86
Figure 4-110 T1 cable
You can also use a network interface connector to extend the FIC-2VTI cable.
The FIC-2VTI cable and network interface connector are optional. Order them together with FIC-2VT1.
By default, they are not supplied.
Connecting the interface cable
z
You should connect a cable to the port with the correct mark. Misplugging is prone to impair the
module and even damage the router.
z
When using T1 cable outdoors, you are recommended to install a special lightning arrester on the
input end of the cable in order to avoid lightning more effectively.
If the FIC has been properly installed, follow these steps to connect the cable:
Step1 Plug one end of T1 cable into the RJ-45 connector of FIC-2VT1.
Step2 Connect the other end of T1 cable to the peer device;
Step3 Check the status of LINK LED on the FIC-2VT1 panel: OFF means the link is not connected. In the
latter case, check the line.
FIC-1VE1
Introduction
1-port E1 voice interface module (FIC-1VE1) can handle dense voice signals in VoIP system. It
provides a CE1/PRI/R2 port, allowing the access of 30 channels of voice signals.