H3C Technologies H3C MSR 50 - Manual (Page 196)

4-1
4
FIC/DFIC
For modular MSR series routers, a wide range of optional FICs/DFICs are available, which provide
abundant interfaces, such as synchronous/asynchronous serial interface, Ethernet interface, E1/T1,
ISDN BRI/PRI, audio interface, Layer 2 switching interface, and so on.
Among this series interface modules, the Layer 2 switching interface modules (FIC-16FSW and
DFIC-24FSW) each have a corresponding PoE-capable one, which can provide -48 VDC power to
remote PDs (such as IP phone, WLAN AP, and network camera) through straight-through network
cables as long as installed on a PoE router.
Ethernet Switching Module
z
FIC-16FSW
z
FIC-16FSW-PoE
z
DFIC-24FSW
z
DFIC-24FSW-PoE
FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE
Introduction
The 16/24-port 10/100 Mbps Ethernet Layer 2 switching MIM interface module
(FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE) is used on H3C MSR 50 series router.
A router installed with FIC-16FSW/DFIC-24FSW modules can work as a switching/routing integrated
device on a small-sized enterprise network to connect PCs and network devices inside the network.
The interfaces provided on the FIC-16FSW/FIC-16FSW-PoE and DFIC-24FSW/DFIC-24FSW-PoE are
as follows:
FIC-16FSW/FIC-16FSW-PoE, which provides:
z
16 10/100 Mbps RJ-45 connector interfaces on the FIC-16FSW module
z
One 10/100/1000 Mbps gigabit RJ-45 connector electrical interfaces on the FIC-16FSW module
z
1 SFP fiber interface (Fiber interfaces and gigabit electrical interfaces share the MAC layer) on the
FIC-16FSW module
DFIC-24FSW/DFIC-24FSW-PoE, which provides:
z
24 10/100 Mbps RJ-45 connector interfaces on the DFIC-24FSW module
z
2 10/100/1000 Mbps gigabit RJ-45 connector electrical interfaces on the DMIM-24FSW module
z
2 SFP fiber interfaces (Fiber interfaces and gigabit electrical interfaces share the MAC layer) on
the DMIM-24FSW module. By default, the electrical interfaces take effect.
The modules support:
z
100 meters (328.1 ft.) of transmission distance over the category-5 twisted-pair cable
z
100 meters (328.1 ft.) of transmission distance between any interfaces over the category-5
twisted-pair cable
z
Operation at 100 Mbps and 10 Mbps, autosensing