beautypg.com

Connecting the interface cable, Mim-1at3, Introduction – H3C Technologies H3C MSR 50 User Manual

Page 124

background image

3-20

Figure 3-21 E3/T3 cable

BNC connector

SMB connector

BNC connector

SMB connector

MIM-1AE3 and MIM-1AT3 modules use the same type of cables for connection, which are called E3/T3
cables in this manual.

Connecting the interface cable

Some measures have been taken to protect MIM-1AE3 module. To achieve better lightning protection
effects, however, you are recommended to add a special lightning arrester at the input end of the E3/T3
cable when leading it to the outdoors.

Step1 Connect the SMB connector of an E3/T3 cable to the Tx port on MIM-1AE3 and another end to the Rx

port on the device to be connected;

Step2 Connect the SMB connector of another E3/T3 cable to the Rx port of MIM-1AE3 module and another

end to the Tx port on the device to be connected;

Step3 Check the behavior of the LINK LED on the MIM-1AE3 panel. It is OFF when fault has occurred on the

link and signal is out of synchronization. In this case, please check the link.

MIM-1AT3

Introduction

1-port 44.736 Mbps ATM-T3 interface module (MIM-1AT3) supports:

z

Two ATM cell mapping modes: ADM and PLCP;

z

Scrambling in data transmission;

z

Both line clock (when working as DTE interface) and internal clock (when working as DCE
interface);

z

Four types of test measures, i.e., local cell loopback, local payload loopback, remote payload
loopback, and remote line loopback.

This manual is related to the following products: